How to Set Up a TriStar PWM Charge Controller with LiFePO4 Batteries
Setting up your Tristar PWM charge controller to work with Battle Born LiFEPO4 batteries is a cinch! Step 1: Remove the access cover. This is the front cover on the unit that is held in with four screws. Step 2: Adjust the first three DIP switches. The first three DIP…
Setting Up a Trimetric Battery Monitor with Battle Born Batteries
When used in combination with Bogart Engineering Solar Charger, the Trimetric TM-2030 Battery Monitor allows the user to precisely alter the charging parameters used on the Battle Born Batteries. Here is how to set up a Trimetric TM-2030 battery monitor and Bogart Engineering solar charge controller to operate with Battle…
Charger Compatibility Table
Whether it be a solar charge controller or a marine grade converter, our customers want to know if their device will work to charge our batteries. We do our absolute best to test every charger we can, and by doing so, we have created this charger compatibility table of products…
Using the OutBack FLEXmax with a Battle Born LiFePO4 Battery
The OutBack FLEXmax is one of the most versatile chargers that we have tested. It has a very intuitive user interface that makes programming it to work with a Battle Born Battery very straightforward. Tools Needed: 1. #2 Phillips Screwdriver 2. Flat Head Screwdriver Before starting, make sure to disconnect PV…
How to Use Powermania MV2 Series Charger With Battle Born Batteries
Powermania MV2 Series Charger With Battle Born Batteries We at Battle Born Batteries are excited about our collaboration with Powermania out of the San Francisco Bay Area. Powermania makes a line of sealed marine chargers called the Turbo MV2 series. These 12 V chargers range in charging current from 12…
How to Use a Tripp Lite with a Battle Born LiFePO4 Battery
Setting up your Tripp Lite RV750ULHW Inverter/Charger to work with Battle Born LiFePO4 Batteries is a snap! Follow this step-by-step walkthrough and you will be ready to get out there and stay out there in no time. Step 1: Locate DIP switches on the front panel (Figure 1) Figure 1:…
Setting Up a TriStar Charge Controller with a Battle Born LiFePO4 Battery
The Morningstar Tri-star PWM works extremely well with any Battle Born battery bank once a few settings are changed. This guide will walk you through those changes to make the installation of your batteries as simple as possible. Step 1: Locate the DIP switches behind the negative power terminals. Notice…
Can I Use the Marinco Charger with a Battle Born LiFePO4 Battery?
The Marinco 6 amp 12 volt charger comes pre-programmed with 3 charging cycles for a quick recovery. Soft Start (<10 V for 30 seconds) Bulk Stage (10 V-14.3 V) Adsorption Stage With the built-in auto sense, this unit will detect a battery’s voltage and automatically start the charging cycle. Once…
Can I use a Magnum MS2012 with a Battle Born LiFePO4 Battery Bank?
About the MS2012 Inverter Charger The MS2012 inverter charger by Magnum Energy is a “pure” sine wave inverter, making it compatible with all A/C devices. These units were built to meet the most demanding environments. Whether it be in a mobile application, off-grid, or a power backup installation, the Magnum…